Franklin electric pumptec plus manual

Pumptec-Plus. The Pumptec-Plus solid state pump protection system is designed for 1/2 to 5 hp single-phase submersible pump motors. Pumptec-Plus protects against a variety of fault conditions. Run and fault lights make diagnosis quick and easy. connections. If Pumptec is wired downstream of the control switch, the control switch may be open. Solid Load Light Pumptec has detected a dry well or underload condition. A. Make sure the pump and motor are matched correctly. B. Check for a blocked pump intake or stuck check valve. C. The coupling between the motor and pump may be www.doorway.ru Size: KB. If set in the manual position, Pumptec-Plus must be reset manually by pushing the RESET BUTTON (D). A FLASHING YELLOW LIGHT indicates an overload condition occurred. This means that the pump system power draw was greater than the normal operating power (calibration) by more than 25% for more than seconds. Pumptec-Plus will not run the .

Protecciones Monofásicas Pumptec. La familia Pumptec de Franklin Electric proporciona la protección de la bomba de alto rendimiento que usted necesita en la profundidad del pozo. Diseñados para monitorear la carga del motor, el suministro de voltaje y para apagar la bomba evitando daños. Franklin Electric Pumptec-Plus High Perfromance Pump Protection. The most sophisticated pump protection system on the market today. Engineered For 1/2 - 5 HP VAC Single-Phase Induction Motors. Use with PSC, CSCR, CSIR split phase sub. pump motors. Solid-State Microcomputer-Based Protetion. Via the monitoring of motor load supply voltage. Congratulations on your purchase of a Franklin Electric pump protection system. Pumptec-Plus is the most sophisticated pump protection system on market today. It is designed to work on any VAC single phase induction motor (PSC, CSCR, CSIR and split phase) ranging in size from 1/2 to 5 horsepower.

Pumptec-Plus. The Pumptec-Plus solid state pump protection system is designed for 1/2 to 5 hp single-phase submersible pump motors. Pumptec-Plus protects against a variety of fault conditions. Run and fault lights make diagnosis quick and easy. local electrical codes, and within franklin electric recommendations, may result in electrical shock or fire hazard, unsatisfactory performance, and equipment failure. franklin installation information is available from pump manufacturers and distributors, and directly from franklin electric. call franklin toll free for information. If set in the manual position, Pumptec-Plus must be reset manually by pushing the RESET BUTTON (D). Página 10 PUMPTEC-PLUS Pump Protection System C. Red Light The red light (C) indicates a line voltage fault occurred and Pumptec-Plus has turned off the pump motor. A SOLID RED LIGHT indicates an under voltage condition (line< VAC) existed.